RedCore R-4 Manual do Utilizador descarregar pdf (Página 8)

Figure 7 – Setting the depth of the bottom nut on a switch using the board as a gauge.

Step 3. Mount all switches to the board, making sure that the switch is square with the board and

seats fully down on the board. Solder 1 connection on a switch and then check for alignment. The

DPDT Switch will be a tight fit.

Figure 8 – Switches and Toroids Mounted

Step 4 Find the polyvaricon tuning capacitor and place it on the board. Put the leads of the

capacitor through the board but don’t solder yet.

Step 5. Mount the board temporarily to the case using 2 nuts on a switch on either end to set the

depth. Don’t over tighten the nuts, but snug them firmly.

Step 6. Fasten the tuning capacitor to the top of the case with the two screws provided. Don’t

over tighten

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

RedCore R-4 Manual do Utilizador Página 8